WITH THE BOYS LAYOUT TUTORIAL - LISA AMIET

To recreate this great layout created by Design Team member Lisa Amiet you can follow the steps below:

Shop the products

 Uniquely Creative Products Used:

·         UCP3151 Far & Wide Paper
·         UCP3153 Next Exit Paper
·         UCP3154 Open Roads Paper
·         UCP3157 Speed Limit Paper
·         UCP3160 Wheels & Wings Creative Cuts
·         UCE2223 Acetate Rustic Ephemera
·         UCE2225 Cogs Overlay
·         UCE1809 12 x 12 Corrugated Card
·         UCE1822 Mixed Metal Cogs
·         UCE1878 Black Pearls
·         UCD2241 Cogs Die
·         UCE2081 Mixed Photo Mats
·         UC Foam Mounts

 Other Products Used:

·         Mini Stapler, Scissors, Trimmer, Die Cutting Machine
·         Double-Sided Tape

Photo size: 3 x 4”

Step 1:   
Use Far & Wide paper as your page base. Adhere cog overlay towards top right corner of your page. Use the Cogs die to die cut cogs from Open Roads Paper. Adhere cogs in the centre of two of the overlay cogs – See image 1
 
Step 2:   
Fussy cut teal tag, measuring tag and paper element from Speed Limit paper and tear teal tag in half. Staple measuring tag to frame creative cut, adhere vent creative cut to paper element. Adhere these to bottom left corner, layering them with a die-cut cog – See image 2.

Step 3:
Tear an approximately 14 x 19cm pieces of corrugated card and adhere to the centre of your page. Fussy cut polaroid stack from Next Exit paper and a 4.5 x 7cm and a 4.5 x 9cm piece, and distress edges of all pieces. Adhere larger piece to the right and smaller on the left side – See image 3.

Step 4:
Adhere polaroid stack to centre of corrugated card. Adhere tab creative cut to back of photo mat and adhere to the centre of polaroid stack. Adhere star element creative cut to large die-cut cog and adhere to bottom left corner, overlapping previous pieces – See image 4.

Step 5:
Fussy cut tag from Speed Limit paper and adhere to top right corner of photo stack, layering along with an acetate ticket and die-cut cog. Adhere the X from the centre of a small die-cut cog to the tag – See image 5.

Step 6:
Adhere large metal cog to large die-cut cog and adhere to bottom right corner. Distress edges of number plate creative cut and tag. Adhere these, layering with acetate pieces and a torn 3.5 x 6.5cm piece of Open Roads paper. Adhere another X from a small die-cut cog to acetate piece and a medium die-cut cog. Using foam dots, adhere bike creative cut, overlapping previous pieces – See image 6.
 

Step 7:
Fussy cut title from Speed Limit paper and use foam dots to adhere to bottom left corner, along with an acetate element. To finish, adhere black pearls to page.